EBP small
EBP25
ewp80 web.jpg02
Alloy EWP115small
EWP130_med
EWP150 small
EBP15

MAW Solutions Ltd    Hanworth TW4 5PY   Phone: 01273 493343   
Email: info@mawsolutions.com

EBP BThe electric booster pump (EBP15) is the smallest in the Davies Craig family of 12-volt water pumps. With its high flow capacity, specially designed hermetic seal and robust magnetic drive, the EBP15 is the ideal product for a variety of pumping applications.

As shown in the Specifications, the EBP15 is compact and lightweight, less than 100mm long and weighing only 245g, so installation can be particularly easy. It is also a very reliable pump,  with sealed motor bearings on a brushless motor, and total segregation between the motor and the water chamber.

Manufactured for Davies Craig by Bosch, the EBP15 has been developed to meet many automotive applications, and can be installed for either continuous or intermittent running. Like all Davies Craig products it has a 2-year warranty.  Applications include:

  • Introduction of pumped coolant circulation to thermo-syphon engined cars. Modern traffic conditions and hotter-burning modern petrol can lead to overheating, which extra coolant flow will cure.
  • For the same reasons, replacement of the original water pump on a number of smaller-engined older cars, and also installation to assist the operation of the mechanical pump on some older cars, up to approx 1250cc.
  • Water-cooled motorcycle engines in bikes, trikes and kit cars.
  • Vehicle heating systems. The EBP15 reduces heater warm-up time and increases water flow directly from the cylinder head to the heater core, giving increased heat even after engine shutdown.
  • When an EWP is fitted to LPG-powered vehicles, an EBP15 should be used to ensure water flow through the gas converter manifold, and so reduce the risk of the LPG injector freezing up.
  • Go kart and hovercraft engine cooling systems.
  • Boats (including salt water cooling systems), caravans and motorhomes.
  • Solar heating systems

Pump Control Options

ebp_hand_large_102  Because of its low current consumption, no relay is required, and control of the pump is simple. It can be achieved in three ways: Using a simple switch, which can be for example the vehicle heater switch. The pump operates when required, under manual control. The simple switch could also be the vehicleís ignition switch, so that eg on a thermo-syphon engine or an LPG-powered vehicle the EBP15 runs all the time that the ignition is turned on.     The second method is to use a thermatic switch such as the Davies Craig model 0401. This method is used when the EBP15 is installed to assist an existing mechanical pump. Have a look at the Switches page for more info. Or, simply wire the pump in so that it runs continuously when the ignition is turned on -  for example, a race bike would probably have the pump running continuously. 

Installationnew_ebp_parts_kit

Click for EBP Installation Instructions


Fitting an EBP15 is generally very straightforward. It arrives with a kit of parts, which comprise two short lengths of connecting hose and four jubilee clips, an electrical wiring harness, and a pair of adaptors. The pumpís inlet and outlet connectors are 20mm diameter, and the included adaptors allow this size to be reduced down to 16mm or 12mm.  The pump is lightweight  and can be supported by the hoses it connects to if convenient, or by a simple bracket or loop tie if required.

A short EBP15 (pump and cable only) is also available when the adaptors arenít required.

 Please feel free to phone us on 01273 493343 to talk about any EBP15 application.